Beardolphinaries
Member level 2
ads inductor simulation
Hi,
I am doing inductor design in ADS and met a problem.
I intended to design an inductor with patterned ground shield on polysilicon layer.
However, I don't know how to connet this shield to ground? Generally two internal ports are connected to the two ends of spiral inductor. And I draw the shield on poly layer. What else I should do?
Thanks for information.
Hi,
I am doing inductor design in ADS and met a problem.
I intended to design an inductor with patterned ground shield on polysilicon layer.
However, I don't know how to connet this shield to ground? Generally two internal ports are connected to the two ends of spiral inductor. And I draw the shield on poly layer. What else I should do?
Thanks for information.