Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to dissolve potting material?

Status
Not open for further replies.
K

kender

Advanced Member level 4
Joined
Jun 19, 2005
Messages
1,425
Helped
138
Reputation
276
Reaction score
39
Trophy points
1,328
Location
Stanford, SF Bay Peninsula, California, Earth, Sol
Activity points
10,035
Folks,

I had a “brick” high voltage power supply, which I’ve fried. I’d like to find out what it consists of, but it’s potted with some hard opaque material (probably epoxy or urethane). Is there a way to dissolve this material without damaging the circuit inside too much?

Thanks,
- Nick
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top