Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

automatic door systems

Status
Not open for further replies.

alec82

Advanced Member level 4
Joined
Oct 25, 2006
Messages
118
Helped
12
Reputation
24
Reaction score
4
Trophy points
1,298
Activity points
1,874
dear friends
anybody know anythings about sensors using in automatic door
best regards
 

These used to be doppler radar, driving by with your speed radar warning receiver would be trigged by these!

Other units uses a simple IR ray, and when broken will open door. These are in use on buses.

/WD
 

    alec82

    Points: 2
    Helpful Answer Positive Rating
even simple limit switches are also used in automatic doors, reed relay along with magnet can also be used
tell us exactly what is your requirement
 

    alec82

    Points: 2
    Helpful Answer Positive Rating
I am currently working with software for the door controller and our client use infrared sensors that are not susceptible to sunlight.
 

    alec82

    Points: 2
    Helpful Answer Positive Rating
thats the problem with photo receivers they get saturated, you should use TSOP 1738 receiver so the transmitter signal has to be modulated at 36Hhz
 

Sensor manufacturers are optex and BEA.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top