Mshafee
Junior Member level 2
Dear All,
I have tried to simulate a printed antenna. When I read antenna parameters, I got Directivity < 1, gain is very small and a very small radiation efficiency, which indicates an error in simulation. Then I have set the radiation box mesh to about lambda/10, I got reasonable directivity, but the values of gain and efficiency are still too low. Anyone can help? Thanks.
Best Regards,
Mshafee
I have tried to simulate a printed antenna. When I read antenna parameters, I got Directivity < 1, gain is very small and a very small radiation efficiency, which indicates an error in simulation. Then I have set the radiation box mesh to about lambda/10, I got reasonable directivity, but the values of gain and efficiency are still too low. Anyone can help? Thanks.
Best Regards,
Mshafee