Leron
Member level 1
plottin a BUS in ADS
Hi All!
i don't know if this is the right forum but it is the only one where i see some ADS friends...
here there is my problem:
I designed a digital circuit with for inputs. Actually each of these inputs represents one bit of a 4-bit word.
I would like to plot a diagram of the input word so i merged the four signals in a bus named I<1:4>, but when I try to plot this I signal in the data display using the bus-trace the result is not what i was expecting. I would like to see the classic "bar" with crossings at word value changes and word value displayed inside, let's say in exadecimal format.
Thanks for the help
Leron
Hi All!
i don't know if this is the right forum but it is the only one where i see some ADS friends...
here there is my problem:
I designed a digital circuit with for inputs. Actually each of these inputs represents one bit of a 4-bit word.
I would like to plot a diagram of the input word so i merged the four signals in a bus named I<1:4>, but when I try to plot this I signal in the data display using the bus-trace the result is not what i was expecting. I would like to see the classic "bar" with crossings at word value changes and word value displayed inside, let's say in exadecimal format.
Thanks for the help
Leron
