Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

using spice model files in shematics-entry based free spice

Status
Not open for further replies.

buenos

Advanced Member level 3
Joined
Oct 24, 2005
Messages
960
Helped
40
Reputation
82
Reaction score
24
Trophy points
1,298
Location
Florida, USA
Activity points
9,116
hi

is there a way for using spice model files in shematics-entry based free spice ?

for example if i have a spice model of a special subcircuit, how can i add it ito a schematics? (in a free schematics based spice, like SwitcherCad, or Tina-Ti) in the schematics, i want to connect them together with some other components, like transmission lines, voltage or current sources...
should i create a symbol, then add the spice model file? how? please describe step-by-step how to do it in switchercad, or other software. where to click, which menu to chose...

(just for your information: i want to simulate spice models, converted from IBIS models, and other signal/power intgegrity related sources. and i dont want to manually write a spice code to use in a command line free spice, but i want to use schematics entry.)
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top