Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
The Basic thing you need to do is define substrate
substrate parameters such as height, relative permitivity, etc.
Then Draw Patch, provide ground plane.
Provide feed & excitaion port **broken link removed**
See this PDF
Ask if any other doubts you have
Added after 5 minutes:
It is better to post in electromagnetic simulation forum.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
