Al Farouk
Full Member level 4
Orc@d Problem
I use Orc@ad 9.0, I draw a small circuit at Capture CIS capture schematic targeting PCB design, the problem contain 1 IC, one relay and some passive component the problem is that when I generated the nellist and BOM the relay dos not appear in the BOM or as a component when I go to the layout although ne error appear while generating the BOM or while importing the design to layout. I wander why this specific component did not appear although the flyweel diod conneted to it and all other component appear in layoput.
dos any one face this problem before ?
I use Orc@ad 9.0, I draw a small circuit at Capture CIS capture schematic targeting PCB design, the problem contain 1 IC, one relay and some passive component the problem is that when I generated the nellist and BOM the relay dos not appear in the BOM or as a component when I go to the layout although ne error appear while generating the BOM or while importing the design to layout. I wander why this specific component did not appear although the flyweel diod conneted to it and all other component appear in layoput.
dos any one face this problem before ?