Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] how to extract a set of specified values by using HFSS8?

Status
Not open for further replies.
G

Guest

Guest
hi,everyone:

Now I am using HFSS_V8 for calculation of a microstrip antenna. The antenna is very simple, just consisting of infinite ground plane, substrate and rectangle radiator fed by coaxial!

What I need to deal with is to extract the values of current at a specified point on the radiator, and I know that this can be done by compiling a file of HFSS_Macro.

But I do not know how to do using macro for I know little about the compiling of HFSS_macro!

Who can tell me what I should do?
 

You can find Macro Guideline to learn!
But I don't know where can download it!
Who knows?

In @nsoft Designer, Macro doesn't exist!
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top