Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Using TCL in NCSIM Postlayout

Status
Not open for further replies.
A

alagendranc

Newbie level 1
Joined
Jul 9, 2008
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,287
Hi Guys,
I am running my Postlayout simulation in NCSIM. Is there a way to find the delay between any two nodes using Tcl commands??
Suppose, I have a memory library "mem" whose timing parameters are provided in the SDF file as
below. (a portion of..)
(IOPATH (posedge CLK) Q[0] (1.6990::1.7609) (1.6980::1.8186))

Now how can I find this path delay using Tcl without going for waveforms.

Regards,
Alagendran.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top