+ Post New Thread
Results 1 to 2 of 2
  1. #1
    Full Member level 4
    Points: 4,285, Level: 15
    Achievements:
    7 years registered

    Join Date
    Dec 2006
    Posts
    215
    Helped
    33 / 33
    Points
    4,285
    Level
    15

    A Question About Delta-Sigma Modulators

    Hi,
    When designing DSMs in simulink, if you don't put limitations for the integrators outputs, they may vary much more than ±Vref. But when you put limitations for the integrators outputs, you should correct the filter coefficients to avoid saturation. How can we do this to obtain the optimum coefficients?
    Thanks.

    •   AltAdvertisement

        
       

  2. #2
    Full Member level 3
    Points: 3,443, Level: 13
    jiangxb's Avatar
    Join Date
    Apr 2007
    Location
    hangzhou, china
    Posts
    153
    Helped
    25 / 25
    Points
    3,443
    Level
    13

    Re: A Question About Delta-Sigma Modulators

    hi naalald,

    my suggestion is that not limit the output of integrator, input the fullscale sine wave for a period of time and record the distribution of integrator's output. set the integrator gain to scale the output within the swing of integrator based on the ratio of the maximum integrator's output to reference voltage. repeat the process and round the integrator gain to a realizable value.


    1 members found this post helpful.

--[[ ]]--