Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: Can anybody tell me how to implement the pci to ide card
Have a look at https://www.opencores.org
They have a PCI controller and an ATAPI controller with a common SOC bus (Wishbone). It will not take much effort to interface these two.
If you are looking only for ATA it should be fine. If you are looking for ATAPI, the core supports only DMA. UDMA is not supported.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.