Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

SAR-specific absorption rate in CST

Status
Not open for further replies.
K

kyg

Member level 5
Joined
Dec 6, 2007
Messages
92
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Activity points
1,857
hello everyone

please help me about SAR-Specific Absorption rate in cst
before simulate with SAR i need to define power loss density
monitor. however after define and simulate i still can't to define
SAR calculation setting.....

before that SAR advantage of this model is that approximates real-
life laboratory measurements so hope anyone can give more
information about SAR

thanks,
kyg
 

hi,

have you specified the material densities? Go to the material properties for each material and enter the mass values accordingly. The mass definition is a must for the SAR calculation.

aw
 

hai...

i am not define the material properties. maybe this step
i don't know because i didn't find from cst help.
thanks i will try this step :D....

thanks

regards,
kyg
 

from the material properties how i can defined the mass
i didn't see the way could u please explain detail or send me a notes cst about sar :cry:
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top