Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Gain bandwith product should be considerably higher than intended gain multiplied with 100 kHz. Most OP will do except for slow ones. E. g. a "slow" 741 with 1 MHz GBW would be absolutely limited to a gain below 10 and should be used for a gain not higher than 2 up to 5.
Thanks FvM...
I already calculate using formula before. I'm also trying voltage follower circuit but i will become attenuation when above the audio signal...this I used normal 741..
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.