Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to design a six digital attenuator?

Status
Not open for further replies.
Z

zkmicrowave

Member level 3
Joined
Jul 4, 2003
Messages
61
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
387
about digital attenuator

who can tell me about the means of the digital?i must design the six
digital attenuator,how design it?
 

Re: about digital attenuator

Digital attenuators are chained attenuators (could be switched by PIN diodes for example, but also they are made as MMIC's). The attenuation control is done by a binary word. You can check the TOAT-R512 from minicircuits or AT-220 from MACOM, for example.

Regards, Al
 

Re: about digital attenuator

recent issues on digital attenuators: the old dig att need a -Vee polarisation and this is not useful in RF PCB, where an inverter can generate spourios. Recently (and they will be produced soon) single voltage dig att are developped...try to look at them for your RF design.
bye
 

Re: about digital attenuator

If you design an IC, check RF2410 (or substitute) on RF Micro Devices site (www.rfmd.com). In the datasheet, they usualy provide description of internal architecture of the IC. This one is done by FET switching of attenuator networks (P or T, you have basics at Odiseus web page, if you need)
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top