Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

need help in rf choke

Status
Not open for further replies.

Amro eid

Member level 5
Joined
Jan 25, 2005
Messages
84
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Activity points
587
hello
i need to know how can i make rf choke for 3.5mhz
it is connected between +b and plate it function allow
the dc to flow and prevent lossing of rf signal is this right?
rf choke which i need is 2.5mh at 3.5 mhz
is there any formula for coil turns,diameter, impedance etc to make
thanks
 

I don't know if it is too low freq. for a choke?
 

thanks
vfone it is useful link

fxxjssc
not low it depend on the first stage osc crystall and add rf amp and it works good
i get it through 300 turne at 1 inch air core i see the osc with scop after 300
i get the max impltude

regards
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top