moraali
Newbie level 3
Good evening
My Board (written on the FPGA board) is
Board Vendor: Xilinx
Board Name: Virtex 4 ML401
Board Revision: B
I have done the tutorial (EDK 9.2 MicroBlaze Tutorial in Virtex-4). I am using Virtex4 ML401, not ML403. However , when I opened the Hyperterminal, the Hyperterminal does not display any output.
My lecturer told me the problem might occur when translating from vhi to vhdl . Can you please rectify my problem. He also told me the problem might occur because when using the BSB the revision board is only '1'. But my board is is written 'B'.
The code is in the attachement.
Please reply to me as soon as possible
Thank you
My Board (written on the FPGA board) is
Board Vendor: Xilinx
Board Name: Virtex 4 ML401
Board Revision: B
I have done the tutorial (EDK 9.2 MicroBlaze Tutorial in Virtex-4). I am using Virtex4 ML401, not ML403. However , when I opened the Hyperterminal, the Hyperterminal does not display any output.
My lecturer told me the problem might occur when translating from vhi to vhdl . Can you please rectify my problem. He also told me the problem might occur because when using the BSB the revision board is only '1'. But my board is is written 'B'.
The code is in the attachement.
Please reply to me as soon as possible
Thank you