Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Problem with programming ATmega32

Status
Not open for further replies.
C

cai2

Member level 2
Joined
Nov 30, 2006
Messages
50
Helped
1
Reputation
2
Reaction score
0
Trophy points
1,286
Activity points
1,618
hi guys!...we have a problem regarding with the programmer of atmega32... Every time we try to load it with a program an icon appears that says, a device is missing,what could be the possible reason why it is not working?
 

Re: atmega32

Hi,
It says your connection to the device is not proper, I hope it is RS232, then look for loose cable, wrong cable etc. Give some more details about your connections to the device, a block diagram or even a detailed cicuit drawing. You should have posted this message under Microcontroller section for better respose.

Regards,
Laktronics
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top