Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to connect microcontroller with a generated DTMF to a phone line?

Status
Not open for further replies.
Re: dtmf problem!!

Hi,
I am sorry, I am unable say anything by viewing the plot, but if all digits (0 to9) BCD outputs you could get from 8870 with your signal input, your signals are ok. Please increase the duration of ON/OFF to 200 msec.each and try it on the phone line again. By the way what are the two plots shown on the oscilloscope ?

Regards,
Laktronics
 

dtmf problem!!

the yellow is analog tone after filtering the pwm that ucontroller generate

the blue is noisy tone signal

the pink is original dtmf signal that the ucontroller generate .

thanks.
 

dtmf problem!!

try this
83_1204155966.jpg


Added after 7 minutes:

More information
 

    segmex

    segmex

    Points: 2
    Helpful Answer Positive Rating
dtmf problem!!

Can i use LM324 for Op-Amp Or NOT....
 

Re: dtmf problem!!

look at this one
 

Re: dtmf problem!!

why do you need an inverting amp, how about a non inverting one ?

ken
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top