Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to unsolder or unbraze a silver-soldered joint between stainless steel and brass?

Status
Not open for further replies.
J

jecson

Newbie level 1
Joined
Feb 3, 2008
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,289
Hi, enjoyed the detailed explanation above on brazing. I have a question going in the reverse direction. How do you unsolder or unbraze a silver-soldered joint between stainless steel and brass without destroying optical components housed within?
 

Re: Remove the soldering

You can try to apply some flux next to the joint and gently heat it up ..
The flux should pull sliver from the joint towards itself ..

There is always an option of cutting the joint with a very thin blade with something like an engraving tool ..

Regards,
IanP
 

Remove the soldering

or you can reheat it using soldering rod and then pull off the unwanted solder using desoldering pump....
 

I don't know the answer to your question but I want to make a guess. Are you want information about brazing so you can go my link Induction Brazing thanks
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top