Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Help: simulation problems about passive Mixer

Status
Not open for further replies.
xiaofeixia

xiaofeixia

Junior Member level 3
Joined
Jul 25, 2005
Messages
27
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,477
I intend to simulate a passive Mixer, when i run the voltage conversion gain, the pss simulation ran very slow or even stopped after several point, who can tell me how to setup the simlation to make it correct, does it the matter of converge?
Thanks a lot
 

Try to reduce the LO input level.
Also if the RF input level is too high and the mixer get into compression the simulator can have problems to converge
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top