Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

MAGMA: Pre route short and spacing violations

Status
Not open for further replies.
P

praneshcn

Member level 5
Joined
Aug 23, 2007
Messages
90
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,288
Activity points
1,899
Hi ,

How do we correct if pre route shorts and spacing violations occur after Final Routing. I had made sure they are not present after power planning but they are present after final routing. So hw do we correct them?



thankz
 

if pre-route shorts and spacing violations did not exist after placement but they r occuring after final routing, please check out the congestion. it must be too high.

try using "run route power2 post_route_refine $m"
 

I have run the command: run route power2 post_route_refine $m
but the errors are still exist
is any other way to fix it?

Thank
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top