+ Post New Thread
Results 1 to 5 of 5
  1. #1
    Member level 1
    Points: 1,132, Level: 7

    Join Date
    Oct 2007
    Posts
    39
    Helped
    0 / 0
    Points
    1,132
    Level
    7

    The diagram of phase shifter which gives 90 degree phase shift

    i want the diagram of phase shifter which gives 90 degree phase shift

    •   AltAdvertisement

        
       

  2. #2
    Advanced Member level 1
    Points: 5,988, Level: 18

    Join Date
    Feb 2002
    Location
    Italy
    Posts
    415
    Helped
    52 / 52
    Points
    5,988
    Level
    18

    Re: phase shift

    Looks the same as the other question I have right now answered.
    Remember that usually the lenght and the accurancy of an answer is directly proportional to the number of words spent for the question.

    Mandi



    •   AltAdvertisement

        
       

  3. #3
    Advanced Member level 2
    Points: 6,801, Level: 19

    Join Date
    Nov 2004
    Location
    Tamilnadu
    Posts
    659
    Helped
    36 / 36
    Points
    6,801
    Level
    19

    phase shift

    for RC ckt, phase angle is inv.tan(RC)..SO PICK RC according to that...correct me if i am wrong....



    •   AltAdvertisement

        
       

  4. #4
    Advanced Member level 1
    Points: 6,213, Level: 18
    flyhigh's Avatar
    Join Date
    Nov 2003
    Location
    somewhere over the rainbow
    Posts
    409
    Helped
    68 / 68
    Points
    6,213
    Level
    18

    Re: phase shift

    quarter wavelength transmission line...

    (but I agree with FANT and think you are just posting to get points as your question is not inteded to get any answer of real practical value.)

    flyhigh



  5. #5
    Junior Member level 2
    Points: 1,076, Level: 7

    Join Date
    Jun 2007
    Posts
    22
    Helped
    1 / 1
    Points
    1,076
    Level
    7

    phase shift

    Hi
    which type of phaseshifter using? For lumped element phase shifter which is switched line phase shifter . formulas to calculate L & C Values are as follows.
    L=Z0/2*Pi*f & C=1/2*Pi*f*Z0
    L & C values for getting phase shift other than 90degree can be calculated by different formulas described for High pass & Low Pass Section.
    You can refer"Inder Bahl " Book(Chapter 12) for Lumped element design.



--[[ ]]--