Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
very simple!
take spar over frequency
calculate Gav and format in dB
then fit the curve with the function:
A=C0*Freq^.5 + C1*Freq^1 [dB]
You have to find C0 and C1, right? ;-)
Then C0*Freq^.5 is the dissipation due to ohmic losses while C1*Freq is the dissipation due to dielectric losses.
Now You may compare, freq by freq the conductor loss with the DC loss and so, calculate the ratio.
The ratio is the conductor section ratio, finally divide by the conductor perimeter, Youll'get the penetration factor.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.