Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Any diff of Gain BandWidth Product and Unity Gain BandWidth?

Status
Not open for further replies.

ZengLei

Full Member level 1
Joined
Jan 24, 2006
Messages
99
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Location
WuHan China PR
Activity points
2,143
There are 2 different parameters

Gain BandWidth Product and Unity Gain Bnadwidth.

My Question:

What's the definition of the two parameters?

What's the differences between the two parameters?

In general,Which is bigger?

In general,When we choose a element such as OP,which one we should take it into consideration?Which one would be ignored compare to the other one?

I post the same topic in another BBS,someone said the two are same,But why must we define the two different parameters even they are same.

ThankS
 

Re: Any diff of Gain BandWidth Product and Unity Gain BandWi

hi i think u can get idea from this link

h**p://en.wikipedia.org/wiki/Gain-bandwidth_product

Added after 4 minutes:

see the attached file to get some more idea on Gain BW product and Unity gain bandwidth
 

Re: Any diff of Gain BandWidth Product and Unity Gain BandWi

see the attached file to get some more idea on Gain BW product and Unity gain bandwidth
 

Re: Any diff of Gain BandWidth Product and Unity Gain BandWi

Both Gain bandwidth product and unity gain bandwidth are same... At unity gain , the gain bandwidth product becomes unity gain bandwith...
 

    ZengLei

    Points: 2
    Helpful Answer Positive Rating
Re: Any diff of Gain BandWidth Product and Unity Gain BandWi

sivakumar_tumma said:
Both Gain bandwidth product and unity gain bandwidth are same... At unity gain , the gain bandwidth product becomes unity gain bandwith...

Gain bandwidth product = unity gain bandwidth only for a single pole system.
When a system has multiple poles and also potentially zeros , then this does not hold good.
For a higher order system (multiple poles/zeros), unity gain frequency would be usually
less than the gain bandwidth product (because each higher order pole creates -20 db/decade
and unity gain frequency would occur faster)
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top