Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

current sensor for 3-phase AC motor??? help???

Status
Not open for further replies.

Kel'Thuzads

Newbie level 3
Joined
Jul 4, 2007
Messages
4
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
0
Hi! everybody.
I want to measure current of 3-phase AC motor.
my method :
- use TI
- current output from TI is rectified by diode bridge.
- after is connected to PGA, --> 0-10V
- then is connected to analog module of PLC

I haven't been tried, for do not make sure. is there another which method another?
please help me !
Thanksssss.
 

Other way is to swap places of diode bridge and pga. Voltage drop on diodes is betwen 0,4 and 1V and this can introduce non linear transfer caracteristic. Also diode bridge can be obmited if one pin of secundar winding is biased to Vcc/2 and rectifying is done by software.
 

thank you! I will try it. I hope to will succeed .
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top