Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Compact Flash to IDE converter (mode 3) issues

Status
Not open for further replies.
woody28

woody28

Member level 3
Joined
Mar 24, 2002
Messages
64
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
448
Compact Flash to IDE

Dear all

I have made a Compact Flash to IDE interface that uses Compact flash I mode 3(true Ide mode) but unfortunately I get error when I partition and formatting it and after reset the system every ting goes wrong and system does not boot from Compact flash.
What must I do? Is anyone having experience with CF to IDE?

Thanks in advance.
 

I used a compact flash I in True IDE mode connect directly to an IDE bus of one ETX module.
Check this:
/http://www.jumptec.de/product/data/pdf/ETXDesignGuide113.pdf
or this( i can't remember, but I think it's the first one)
/http://www.jumptec.de/product/data/etx/ETXSpecV2.6.pdf

And search for the example where they connect on CF to the IDE bus of the ETX. It's the same as connecting one CF to a PC IDE bus. I try that and it worked. Jus't don't use the same IDE bus with other device. I had problems when I connected one disk drive with the CF in the same IDE bus. Only worked when disk was master and CF slave, but even that didn't worked very well....
 

Check this

**broken link removed**
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top