Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
The unity gain buffer is used to decrease voltage step at the CP output at turn on. Due to charge sharing between the output node and both other sides of the N or P switch, the voltage at the CP output shows a step when both swirchs are turned on, while in idal case the output, which is the control voltage should remain quite... to decrease this effect the buffer is added...
The unity gain buffer is used to decrease voltage step at the CP output at turn on. Due to charge sharing between the output node and both other sides of the N or P switch, the voltage at the CP output shows a step when both swirchs are turned on, while in idal case the output, which is the control voltage should remain quite... to decrease this effect the buffer is added...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
