Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Structure loses segmentation when imported to CST 2006B

Status
Not open for further replies.
R

rfmw

Advanced Member level 2
Joined
May 10, 2001
Messages
543
Helped
93
Reputation
190
Reaction score
51
Trophy points
1,308
Activity points
3,979
I have a very well segmented structure and when I import this structure (.SAT v14 format) into CST 2006B, the structure is very poorly segmented. Only corner points/dots are vertices, all other are lost.

Imagine (metal) thin sheet area 1cm x 1cm with 1mm segmentation - so 11 points per edge. Now this structure in CST would have only 4 corner points, all others are gone.

What am I doing wrong? Does these points/dots/vertices influence meshing? I believe so...
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top