bmichel
Newbie level 4
Hi everybody,
I replaced the power supply PWM controller (TEA2262) dead and Q510, Q503, D596 all dead. I also checked or replaced some involved cap's
A second after power-on, the power & Saving LED are blinking while the Geom LED is on. Nothing else.
I already took a look at the internet but there never was a satisfactory information about the meaning of those LED.
When I check the TDA8138 dual voltage regulator ( 5V & 12V), 12V is off by the disable function (pin 4), signal coming from IC801 (ST7271...)
You can help me if you already fix this problem or if you own the real service manual (I already own the schematics).
Many thx
I replaced the power supply PWM controller (TEA2262) dead and Q510, Q503, D596 all dead. I also checked or replaced some involved cap's
A second after power-on, the power & Saving LED are blinking while the Geom LED is on. Nothing else.
I already took a look at the internet but there never was a satisfactory information about the meaning of those LED.
When I check the TDA8138 dual voltage regulator ( 5V & 12V), 12V is off by the disable function (pin 4), signal coming from IC801 (ST7271...)
You can help me if you already fix this problem or if you own the real service manual (I already own the schematics).
Many thx