Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Search results

  1. Y

    RL circuit differential equation

    Have been given a few practice questions to work on but have no idea where to start, im quite confident i Can do the main maths behind it eg general and complimentary solution but I'm struggling to get from this start to that point! Any help would be greatly appreciated thanks Find the current...
  2. Y

    Basic Op Amp analysis

    hi all have a standard inverting op amp where R1=10k, R2=10k Vin=1Volt and i have been told to find the output voltage for this Op Amp and state any basic assumptions i make. Any idea where i need to start? any help would be appreciated thanks
  3. Y

    Matlab strings identify numbers

    Basic Matlab question i just cant get my head around, have been asked to write a program that will read a mixed string containing letters and numbers from my keyboard. i must then count the amount of numbers that are present in the string, could anyone point me in the right direction?? thanks!
  4. Y

    basic signal question

    doing experiment in the lab at school using harmonic synthesiser, oscilloscope and Vrms voltmeter to create different types of waves. one part involved entering a loudspeaker into the circuit and turning it on and off to see the effect it had on the waveform on the oscilloscope screen. i noticed...
  5. Y

    Proteus 7 encoder and decoder

    Have drawn an encoder and decoder layout using proteus 7 isis but for the designs to be able to be turned into pcb they have to be moved to ares! any ideas how to start this process?
  6. Y

    simple diode full wave rectification!

    Just a simple question, for a 4 diode bridge full wave rectification circuit with input of 12Vac supply i have measured voltage on scope to be 19.2V, when voltage measured across load was taken it measured 12.2volts on my DC multimeter! now i know that the meter is reading the average voltage...
  7. Y

    proteus ares and isis

    anyone know where i can get proteus 7 online free TO DOWNLOAD? have a coursework involving moving a design from ares to isis so as long as package contains them thats great. if not, how much would i be looking to pay for it?
  8. Y

    increasing capacitance! basics

    have an ac supply a diode and a load resistor in series. After placing capacitors of varying values across it i found that with increasing capacitance the amplitude of the waveform on the oscilloscope decreased showing a smoothing effect! can anyone explain to me why this happens?
  9. Y

    half wave rectification circuit with diode and load resistor

    I have a circuit with a 12V AC supply adapter frequency of 50Hz, one diode and a 100K Load Resistor all in series. i have set the multimeter to DC like instructed and i have measured the voltage across the load resistor to be 5.8 Volts but i'm rusty on the theory as to why i have gained this...
  10. Y

    Simple Diode Circuit for half wave rectification

    I have a circuit with a 12V AC supply adapter frequency of 50Hz, one diode and a 100K Load Resistor all in series. i have measured the voltage with a multimeter set to DC across the load resistor to be 5.8 Volts but i'm rusty on the theory as to why i have gained this value. As the supply is 12V...
  11. Y

    Basic Electronics help needed!

    have used a development board to create a small circuit containing a 12V supply plugged into an analogue development board which contains a 100mA fuse. After this i have attached an oscilloscope across the two inputs to complete the circuit and this created a sine wave image on the scope. When...

Part and Inventory Search

Top