Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi power electronics experts,
We have designed a solar inverter of 10KW capacity. We had 3 single phase inverter in which each phase carries 3500W capacity. We have loaded and tested the system fine and which has no issues. In order to filter the waveform we have introduced LC filter.
I guess your switching frequency is very high as far as inverter is concern. Just cross check that your IGBT can be used with this higer frequency. I am suggesting you the optocoupler VO3120 opto isolator which can operate between 15v to 35v with higher switching frequency.
My swithing frequency for high side is 18KHz. For low side 50Hz square wave. IGBT is getting shorted at the moment of supply and gate signal is available. No ringings or spikes present in my input 315v DC.
I guess my issue might be as follows.
There may be some rise time and fall time in the IR2110 which doesn't match with the sequence of the opposite IGBTs. It wasn't detected when i check the signals without supply to H-BRIDGE.
I suspect that when the IGBT is powered, the rise time and fall...
my igbts are upto my rating. its 650v/40amps rated.
i checked the driver output waveforms at the gate without power supply to the igbt. it was in the specified sequence as i am expecting. it was initially worked upto 2200 watts load. i turned off it and when restart it after half an hour...
I am using the same 315V DC to my SMPS which outputs 3.3v and 24v supplies. It runs with out any issues. It's just a full wave rectifier with 4700uF/450v filter caps. And also a capacitor bank comprises of 20x470uf/1000v caps.
Warm regards to u all...
I have designed a solar inverter with IR2110 driver. I have attached the schematic for one section of high side. When i check the pulses across the gate and emitters of each IGBT is proper. When I give 315V DC to my H bridge, One of the high side and...
30uV is no load ripple. on Load regulation it was mentioned 200mV...
- - - Updated - - -
Thank you for your info godfreyl. And sorry I was mistakenly took dropout voltage as noise voltage.
Can you please give me circuit for tps73633
- - - Updated - - -
I need the current output upto the...
I need a regulator circuit that should give ripple as minimum as possible on load.
I'm currently having a RPS which gives 600mV peak to peak ripples as i monitored on scope.
It making my ADC value to get oscillate around +/-32.
Can someone help me???
if A = 0 ==> Z= [EF+!BC+D][!D!E+!BC+!D!E]
take !BC as common term,
Z = !BC[(EF+1+D)(!D!E+1+!D!E)]
since 1+A = A,
Z = !BC[(EF+D)(!D!E+!D!E)]
since A+A = A
Z = !BC[(EF+D)(!D!E)]
Z = !BC[EF!D!E + D!D!E]
since A!A = 0
Z = !BC[0+0]
==> Z = 0