Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi Mentor :-) ,
I am a newbie in electronics.
I have studied electronics in academics. All it was theory.
But if you go for job the practical electronics is used.
And we have to learn how to convert theory which u learnt in academics to practical version.
My point is I want a simulation...
I want to make a project Water Level Controller and want to know about different type of sensors used for UnderGRound Tank and OverHead Tank.
Are there sensors which show the Upper Level and Lower Level of Water in OverHead Tank.What are those sensors?
Thanks in advance.
How are You?
I am a new Bee.
If I see a circuit it is filled with various Ground like Earth and Ground and Digital Ground and Audio Ground. What is the difference in all those Grounds. Does all give 0V or there is somthing else which I don't know.
Thanks in Advance
Hi Mentor :-),
I am a new Bee to electronics.
If I have a circuit consisting of various Ics and Power supply circuit. If I do some modification to the circuit i.e suppose I want to add a LED to the Line of one IC may it be Micro controller, or want to add Pull up resistor to the pin which...
How are you?
I am a beginner in electronics. I have studied Electronics in College but that was all theoretical.
If I want to design a circuit how to use that theoretical knowledge to convert to practical knowledge.
Do we require imagination power of how current flows how voltage...
I am a beginner in electronics. I want to know that what value of resistor to be used for LEDs. Also when LEDs are in parallel and when they are connected in series.
What all happen internally means how much current flows . How much voltage gets drops. and does the current flowing...
Hi Mentor, :-)
I am a PCB layout designer and I want to know about PCB Reverse Engineering .
The tools and techniques involved. The whole Process.What Should I require(tools) to do reverse Engg.
And also about how a black blob PCB reverse engineered. and how to reverse engineer a more than 2...