Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I want to run spectre simulation of transformer, how can I add following characteristics into my spectre simulator to run the simulation properly?I found only turns ratio of default xfmr device can be modified.
Open-circuit inductance: 1.2mH
While doing my op-amp design, I found the sourcing and sinking ability of my AB output was poor, the current is around 40mA far below requirement.
How to improve this performance?
Thank you in advance.
I try to download the video lecture of EE142 from https://webcast.berkeley.edu/course_details.php?seriesid=1906978242
but I can not download them by link like"rtsp://184.108.40.206:554//bibs/f2005/group3/ee142/20050830.rm"
who can kindly tell me what is the valid download...
Thank you for your replies.
The ckt snapshot is too large to be attached here, how could i be able to present full schematic? Or can I send you the schematic by email respectively?
This test result is totally different from simulation, and i verify that the internal CFB loop is very stable and...
Please take a look at the picture.
I have a bad result while testing my LVDS transmitter chip.
Though the Vcm and Vdm of transmitter output is correct, there is great noise signal generated at transmitter output node. It seems as if the noise been amplified a lot, this noise became even...