Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Laser Soldering: minimum hole applicable and depth? :arrow:
I need to ensure that the press fit pins are very stable by applying solder to it and the best method I can think of is laser soldering after SMT + Press-fitting the connector. Unfortunately the hole diameter is 0.3mm and...
Hi forumers, I have an upconverter module rated 60W with gain of ~40dBm. I am currently connecting the 30dB 150W attenuator directly to the output port (N-type). I am planning to put the attenuator inside a testbox, so I will be using a test cable to connect the DUT. Is it safe to do so? Thanks...
Thanks for your inputs guys. Not much concern on the loss, but on frequecy; so if I use a low freq cable, say less than 5 GHz from SNA RF out to bridge's RF in, is not an issue if my DUT is in 30GHz+ range?
How to make accurate channel power measurement (in my case using 8563E). I am seeing differences when using power meter. Using spectrum analyzer, the difference is also significant when CW is on and off from source (around 2dBm). Thanks guys.