Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Search results

  1. S

    where can i look for a project

    hello you can find these in site www.fpga4fun.com and google search, too
  2. S

    Protel DXP doesn't identify hardware connected to PC by JTAG

    Re: problem hello thanks alot first I make (compile,synt,build)by protel DXP and then programming IC with Ise software (impact) and when programming is finished,computer give this message " programming successful". but hardware don't work. I don't Know what problem it is. please help me
  3. S

    Problem with running a program on Spartan 2

    hello I have a problem about programming Xilinx. I program IC Spartan 2 (xc2s150-5pq208) but my program don't run on hardware at all. even first test that generated a pulse on a pin. the pin always remain 1 I don't know what problem it is. please help help help me
  4. S

    Protel DXP doesn't identify hardware connected to PC by JTAG

    hello My project is fifo by fpga it must do with protel DXP. I used tsk51a_d and made vhdl program . while hardware connect to pc by Jtag but the software(protel DXP) don't identify. of course fpga IC is Spartan2 (xc2s150-) even edif , syn , place, map are generated. What do I do? please help me
  5. S

    "Done pin didn't get high" error when programming Spartan 2 in slave serial mode

    "Done pin didn't get high" error when programming Spartan 2 in slave serial mode hello Do somebody help me ? My problem is about programing Xilinx Spartan 2 (xc2s150 ) I program it by ISE 6.3 software when it's programming in mode slave serial,give a error massage. Done pin didn't get high...
  6. S

    Help me write C program for TSK51

    tsk51 design hello My project is "design FIFO by FPGA" . I must work by "DXP Protel " . I used TSK51 in my design.Now I want to write C program . This program is following : 1- inter Data by Keypad 4*4 in Write mode 2- display data on LCD in read mode please help me thanks
  7. S

    Help me with designing fifo

    design fifo Hello, I should design it with "DXP" microsoft . I should use TSK51A or TSK51 for building fifo with the microsoft. please help me.[/code]
  8. S

    Looking for fifo build by fpga

    building fifo by fpga Hi people, Could anybody go forward and build something? Any interesting to share ?? Regards,

Part and Inventory Search

Top