Search results

1. design of ferrite core (toroid) current transformer for 50 Hz or 27 Mhz

We would like to expand the frequency range to 50Hz - 100kHz But based on following figure I am not quite sure this will be possible with the vitroperm core.
2. design of ferrite core (toroid) current transformer for 50 Hz or 27 Mhz

ah ok, thank you. If we increase the windings of the secondary to increase the voltage at its terminals, what are the consequences? I've read that the higher cut off frequency will go down because of the leakage inductance and stray capacitance. But is there any formula to estimate the higher...
3. design of ferrite core (toroid) current transformer for 50 Hz or 27 Mhz

if we use a tape wound core the lower cut off frequency will easily be under 50 Hz. But what about the sensitivity = R(shunt)/N(windings) ? if we use an active I/V converter, then R = 0 (ideally) so the sensitivity will be also 0? after the current transformer we want to filter the signal (to...
4. design of ferrite core (toroid) current transformer for 50 Hz or 27 Mhz

Indeed, my apologies, the higher currents are for the 27 MHz design In the 50 Hz design, i need to able to measure mA's And I am a student in electronical engineering, but I am fairly new to the design of transformers. I can calculate the inductance of the secundary coil ( L = A_l * N^2 ), but...
5. design of ferrite core (toroid) current transformer for 50 Hz or 27 Mhz

Hi, I want to make a toroid current transformer with a large aperture so that it can fit around the arm or ankle. The current transformer is meant to measure the induced current in the body ( arm or ankle ) caused by electromagnetic fields. I found some ferrite toroid cores on ferroxcube.com...