Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
thank you again for the advice Pancho,
i am going to read again,more carefully the links.
sorry for the unwanted information that i posted.
---------- Post added at 17:00 ---------- Previous post was at 16:51 ----------
Hello Pancho,thanks again.
yes i can understand you are telling me...
hello pancho,thanks again for helping.
in my design i had to used an upconverter and a downconverter.
when i used the component SDC_AMFA and SDC_AMUFA as cosimulation for up and down converters i get the error message with the dublicate variable:LOpower_dBm.
when i used only the SDC_AMFA this...
i believe this one is the correct one.
i made some other changes(replace the one converter) and now i am getting errors for the Tstep and other time parameters which i had change also.
so i believe i must correct them.
i also used transient analysis in cosim blocks and not the...
i currently simulate a digital block diagram model in ADS and i get these warnigs:
but i don't have any "floating pin" in my circuit.
could anyone help me, figure out the simulation problem?
thanks in advanced.