Search:

Type: Posts; User: senmeis

Page 1 of 4 1 2 3 4

Search: Search took 0.02 seconds; generated 31 minute(s) ago.

  1. Replies
    0
    Views
    768

    Closed: Description of telemetry transmitter

    Hi,

    the following statement is taken from the telemetry standard IRIG Standard 106-11:

    The RF signal is typically generated by filtering the baseband non-return-to-zero-level (NRZ-L) signal and...
  2. Replies
    1
    Views
    1,168

    Closed: channels in GNSS receiver

    156449

    Hi,

    the structure of a general GNSS receiver is attached. Question: can this receiver only process three channels?

    Senmeis
  3. Replies
    1
    Views
    258

    Closed: Re: Slat vs. tile arrays

    Sorry, this article is attached.
  4. Replies
    0
    Views
    210

    Closed: Scrambler function question

    Hi,

    in some standards such as JESD204B or DVB-S2 a so called scrambler function is defined. As far as I understand this scrambler is a means of spreading spectrum but in data link layer. Is it...
  5. Replies
    1
    Views
    258

    Closed: Slat vs. tile arrays

    Hi,

    I’m reading this article https://www.microwavejournal.com/articles/27652-tile-arrays-accelerate-the-evolution-to-next-generation-radar156057 about tile architecture in active phased arrays....
  6. Replies
    3
    Views
    456

    Closed: 1dB compression point and jamming signals

    Hi,

    I’ve heard that the 1dB compression point of LNAs can play a role against jamming signals. Shall this 1dB point be higher or lower? Are there any articles about this issue?

    Senmeis
  7. Replies
    0
    Views
    616

    Closed: TDMA vs. FDMA in Satcom

    Hi,

    I noticed most of the satcom products are TDMA-based. Can anyone explain what is the advantage over FDMA which is also available on the market?

    Senmeis
  8. Replies
    2
    Views
    374

    Closed: Fixed load of wave guide

    Hi,

    how does a fixed load of wave guide (to mitigate reflections) look like, pyramid shape?

    Senmeis
  9. Closed: “curve-fit based” method for III-V devices

    Hi,

    I’ve heard that the commonly used “curve-fit based” method which is valuable for IV-IV semiconductors, is not so accurate for III-V devices such as GaAs. Is this statement correct?

    Senmeis
  10. Replies
    3
    Views
    1,296

    Closed: Re: I/Q data and envelope

    I think the most important characteristic is, the swings between envelopes must disappear. Can this operation support this?
  11. Replies
    3
    Views
    1,296

    Closed: I/Q data and envelope

    Hi,

    How to understand this statement:

    The digital processing computes the root sum of the squares of the I and Q data, which is mathematically equivalent to an envelope detector?

    Does it...
  12. Replies
    1
    Views
    1,145

    Closed: vibration rejection in IMU

    Hi,

    One spec of an IMU is: ±450 deg/s wih high vibration rejection.

    Question: Shall vibration have the unit “deg/s”?

    Senmeis
  13. Replies
    1
    Views
    422

    [SOLVED]Closed: Measurement range of signal analyzers

    Hi,

    the following description is taken from a document of signal analyzers:

    A spectrum analyzer with a 24-dB noise figure will have an average displayed noise level of –110 dBm in a 10-kHz...
  14. Closed: Re: GNSS+INS ultra-tightly coupled navigation system

    I asked this question because of this description „accept NCO commands from external sources“ from the attached slide.

    Senmeis
    152510
  15. Closed: GNSS+INS ultra-tightly coupled navigation system

    is it true, in a GNSS+INS ultra-tightly coupled navigation system the GNSS receiver sampling is controlled by INS output?

    Senmeis
  16. Replies
    2
    Views
    2,472

    Closed: Re: Two scale factors in IMU

    I’m not sure if the „scale factor in-run stability“ is related to the case when the IMU stands still. Attached is an example of both parameters. It seems scale factor in-run stability is measured...
  17. Replies
    2
    Views
    2,472

    Closed: Two scale factors in IMU

    Hi,

    an IMU has two parameters:

    scale factor repeatability = 1000 PPM (1-sigma)
    and
    scale factor in-run stability = 250 PPM (1-sigma)

    Question: What is the difference...
  18. Replies
    0
    Views
    220

    Closed: Digital phasing in feeds

    Hi,

    in this data sheet http://www.tcs.la/Portals/0/TCSFeedsAndRFTechnology.pdf the terminology „digital phasing“ is refered. How does this digital phasing work exactly? Is DSP required for it?
    ...
  19. Replies
    1
    Views
    904

    [SOLVED]Closed: dual axis tracking antennas

    Hi,

    What axes are meant in „dual axis tracking antennas“? Azimuth and elevation? Is there alternative interpretation?

    Senmeis
  20. Replies
    5
    Views
    3,067

    Closed: Re: overhead keyhole question

    In this document it states also:

    Digital demodulation and Autotrack phasing at the controller.

    I think demodulation shall be conducted in a Modem, why controller here?

    Senmeis
  21. Replies
    7
    Views
    3,047

    [SOLVED]Closed: Re: Piezoelectric vs. MEMS accelerometers

    OK, is this understanding correct: PE is better than VC but both can belong to MEMS?

    Senmeis
  22. Replies
    7
    Views
    3,047

    [SOLVED]Closed: Re: Piezoelectric vs. MEMS accelerometers

    Please find the source of this statement in the attachment.

    Senmeis
  23. Replies
    7
    Views
    3,047

    [SOLVED]Closed: Piezoelectric vs. MEMS accelerometers

    Hi,

    Is it correct that piezoelectric accelerometers generally have higher resolution than MEMS ones?

    Senmeis
  24. Replies
    4
    Views
    376

    [SOLVED]Closed: opto for power isolation?

    Hi,

    Can opto isolation only be used for signal isolation or also for power isolation? What about capacitive isolation?

    Senmeis
  25. Replies
    7
    Views
    2,967

    Closed: Re: Tracking in satellite communications

    The technology you described is called “Four Horn Monopulse” in radar tracking. Obviously is operates in RF domain. In radar mono pulses are required. Can this be satisfied in communications?
    ...
Results 1 to 25 of 99
Page 1 of 4 1 2 3 4