Search:

Type: Posts; User: PA3040

Page 1 of 20 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    8
    Views
    852

    Closed: Re: Motor Driver for Corona Robot

    This thread is going to out of the original question
    Thanks for your advice . it is very helpful to get red of the my question
    my problem has been solved . Thanks for every one
  2. Replies
    8
    Views
    852

    Closed: Re: Motor Driver for Corona Robot

    Our country has lot of thing to do with this for corona , do not issue the words if you do not have reply

    - - - Updated - - -



    Yes this may be ideal but our country do not have this . anyway...
  3. Replies
    8
    Views
    852

    Closed: Re: Motor Driver for Corona Robot

    Thanks for reply

    Operation voltage is 12v - Car Battery 35A
    What is the H Bridge IC that you are recommended

    Thanks in advanced
  4. Replies
    8
    Views
    852

    Closed: Motor Driver for Corona Robot

    Dear All,
    Have a nice day

    We are planing to make a RC robot to use in the hospital to treat corona patients
    We are going to use H-Bridge to drive the Motors
    Please advice the ideal Two MOSFET...
  5. Replies
    0
    Views
    2,056

    Closed: Corona robot ( Covid 19 )

    Dear All

    We are planing to make a robot which can treat corona patients remotely
    Currently we are getting ready to control robot using drone transmitter

    Can I have the idea and support to...
  6. Replies
    9
    Views
    1,989

    Closed: Re: problem with arduino

    Digits refresh rate and delay should be equal for every digits

    Save the values in array and use PORTD for Segments
  7. Replies
    4
    Views
    736

    Closed: Re: Bulk capacitor series with 1 ohm resistor

    I also believe that this may be used protect from surge current because at the beginning of the capacitor consume high current and result is low voltage at the output, then regulator try to increase...
  8. Replies
    4
    Views
    736

    Closed: Bulk capacitor series with 1 ohm resistor

    Hi

    I found attached schematics image which has red cycle that has bulk capacitor series with 1 ohm resistor . Can I know the reason series resistor hare as well as the capacitor does not mention...
  9. Replies
    7
    Views
    1,153

    Closed: Re: Display current location of the vehical

    How should i get the google map coordinates to micro controller, Without using GPS

    - - - Updated - - -



    Yes..It is predefined routes

    Still I am not clear how should i read rectangular...
  10. Replies
    7
    Views
    1,153

    Closed: Re: Display current location of the vehical

    Thanks for the reply

    Yes...I can find the codes

    Can I able to find coordinates using google without visiting the exact location with GPS sensor?
    Can I use google map to find location very...
  11. Replies
    7
    Views
    1,153

    Closed: Display current location of the vehical

    Hi All

    I need to display current town name on a LCD near the passenger seat of the bus

    This is the things I supposed to use

    Microcontroller
    LCD
    GPS sensor
  12. Closed: Re: Automatic temperature controller using pic 16f877a [MOVED]

    What is the value the LCD is showing

    Is value of the LCD changing when the temperature increasing and decreasing
  13. Replies
    5
    Views
    4,303

    Closed: Re: Protect children from the bomb blast

    - - - Updated - - -



    Thanks for the reply

    Explosive sample can be able to have by the government once we have develop the device certain extend
  14. Replies
    5
    Views
    4,303

    Closed: Protect children from the bomb blast

    Dear All

    Three weeks ago ( 21/Api/2019) our country was attacked by the terrorist blasting 9 bombs in 8 locations . 253 peoples were killed and more than 400 injured. All schools were closed up...
  15. Replies
    56
    Views
    13,949

    Closed: Re: Counting pulses from external source PIC16F877a

    Most honestly

    your comments from post #48



    I didn't see any reason not to work the code you posted on #48 and it must LED flash once a time every 30 switch press
  16. Replies
    27
    Views
    2,451

    Re: How to start counter when sensor is activate

    Where the codes that you tested last
  17. Replies
    4
    Views
    1,303

    [SOLVED]Closed: Re: Problem programming a 16F1708 using PICKIT 3

    Use MPLAB IPE

    which is specially design for PICkit3 . Once you installed MPLABX 3.25 then MPLAB IPE on your desktop

    https://www.youtube.com/watch?v=GOVMcP46GB0
  18. Replies
    27
    Views
    2,451

    Re: How to start counter when sensor is activate

    What is this project ?
    Is it wall follower robot (Micromouse )
  19. Replies
    15
    Views
    4,733

    Closed: Re: IC used for On Off switch

    Grate thanks for detailed info


    It is answered by d123 which I see later that you have modified the answer

    Thanks once again

    Just simple question that you mention it is old fashioned
  20. Replies
    27
    Views
    2,451

    Re: How to start counter when sensor is activate

    // PIC16F877A Configuration Bit Settings

    // 'C' source line config statements

    #include <xc.h>

    // #pragma config statements should precede project file includes.
    // Use project enums instead...
  21. Replies
    27
    Views
    2,451

    Re: How to start counter when sensor is activate

    This is the good point to rectify the issue
    Learn by doing it

    Can you imagine why it is blinking one time
    Can you modify the code with internal clock to blink continuously
  22. Replies
    27
    Views
    2,451

    Re: How to start counter when sensor is activate

    Is LED blinking with internal clock ?

    check and confirm us



    TMR1CS = 0; // Internal clock (FOSC/4)
  23. Replies
    27
    Views
    2,451

    Re: How to start counter when sensor is activate

    In this situation you have to test your code in various location

    For me your #1 post code is correct except baileychic is pointed out with delay

    Fist experiment



    TMR1CS = 0; //...
  24. Replies
    6
    Views
    685

    Closed: Re: Intel® Core™ i3-350M Processor

    Most honestly you would help this

    https://www.intel.com/content/www/us/en/products/docs/processors/core/core-technical-resources.html

    Intel have presentation materials for educators and...
  25. Replies
    15
    Views
    4,733

    Closed: Re: IC used for On Off switch

    d123 Thanks for info


    Please fine the what I should required

    152714

    The above image is used LM2576 power regulator . I need to connect it EN pin ( ON OFF pin) to soft on off ic

    Hoped...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4