Search:

We have tried to connect the flickering unit ground and non-flickering unit ground using jumper wire but not helping....if the ground have problem, why using hdmi doesn't flicker...It flickers only...

From one of the flickering unit ground & neutral is 1.36Vac....but from good unit is 0.7Vac....is it safe to add jumper to short ground and neutral from flickering unit? thanks

My apology mr Klaus...i read your posts am done checking your advice in post#2....but all ok when we compared with non-flicking units.

- - - Updated - - -



OK let me check this out...we...

OK today we found something new today....when we dont connect the ground to the cpu and monitor supply the flicker goes out. I mean from the ac power plug going to the pc/monitor only live and...

Yes..since the start about 10yrs ago...only this moment people decide to take action "(.

Hello again...we have about +1000 of lcd displays in the fab, around 40% of it are flickering (but text still readable). Our facility staffs check all groundings from those flickering but all were...

Ok FvM...I will google more about the pin configuration...And yes i believe you're right...This part is misdiagnosed. The problem is, I disposed the part already into scrap bin and thrown...

Thanks for the inputs...but the low-ohm pins are the middle pin and the 3rd pin...Which based from JFET TO-92 pin configuration the pins are Source and Gate...So it should not read low-ohm, right?...

Really my apology FvM...sorry you guys confused my information and some incomplete...Do you want me to trace more or any data you requires please enumerate to me and i try my best to provide...thanks...

I tried removed and discharged all pins by shorting it...But the low-ohm still remain about 10 ohms. And i believe it can't be middle pin and 3rd pin got low ohm in TO-92 right?

The original part actual is shown in the image below. I found it shorted (pin2 & pin3). The problem is I couldn't find that component online. Even datasheet is hard to find. Thus I am now having...

It acts like electronic switch that turns on/off the bulb. It's either mosfet or transistor. Need more opinions from experts...thanks in advance.

My apology that I wasn't able to mentioned early....I dont have schematic diagram ... I did trace and sketch the drawing myself...I can do more sketching if the drawing is not complete to...

Hello all again and good day....I need some advice from the attach drawing, can someone please tell me if Q130 is a transistor or mosfet? If so, what pin is pin1,2,3? Hoping for your continual...

Great! thanks for the clarification...

Will connect the resistor in series with halogen :-)

I found the part number in ebay, it says Mercury Vapor UV Emitter Bulb.

Any tips and/or info on how to extend life of UV lamp. Thanks in advance.

OK so for this case, I will use resistors. I got here 20-ohm/25W (18qty) + 10-ohm/20W (2qty). Total 380-ohms. I want to test with 1A load set-up...Thanks to all.

Thanks for all the knowledge sharing guys, ok i will try using resistor method first :-)

Ok i replaced the TG179 with mosfet TN0604N3...Will update you once we test at machine. Probably by next week...Wish me luck :-)

Thanks, possible to share the schematic diagram? Or are you selling this unit?

Hello again all...I got a 380Vdc (2 to 3A) power supply here, i am on the way of building a load test station. First i thought of using a series of high power resistors. But have heard that...

Hello All...this TG179 for me is mosfet and not transistor....Because of zener diode connected on the middle pin which i believe a gate pin. Any opinion from you guys? thanks

Hello Brian...this actually the original specs from the machine.