Search:

Type: Posts; User: neazoi

Page 1 of 20 1 2 3 4

Search: Search took 0.04 seconds.

  1. Closed: Re: Passing both DC and pulses through a toroid?

    So a big transformer core that is saturated less easily, would allow DC to pass from the primary to the secondary?
    That's really new to me, if I understand this ok!

    - - - Updated - - -



    If...
  2. Closed: Re: Passing both DC and pulses through a toroid?

    Thanks a lot!
    Please help me understand the thing with my second question, if the DC is in one direction in one primary winding (assumming no saturation) and if my 0-5V edge is at the opposite...
  3. Closed: Passing both DC and pulses through a toroid?

    Hi,
    Suppose I have a toroidal core and I wind one turn of wire through it, as my primary.
    My secondary is also one turn through this core.
    For the next description assume no core saturation at...
  4. Replies
    2
    Views
    165

    Closed: At45db041b vs at45d041

    Hi I have a AT45DB041B connected to the ICSP of the atmega644 and stores data ok.
    I am trying to replace it with the through hole AT45D041 which seems identical to me apart from the 5v requirement,...
  5. Replies
    37
    Views
    2,129

    Closed: Re: HP 54520A Blown Fuse Problem

    I have removed the common mode choke and put wires in it's place. Fuse still blown :( At least the thermistor did not blow, but it may be lust luck.

    I remember I had tested the external RFI...
  6. Replies
    37
    Views
    2,129

    Closed: Re: HP 54520A Blown Fuse Problem

    Hi,
    the problem was not the bridge :(
    after a few seconds or tens of seconds it blows the fuse.
    I have located the problem in it's switching mode PSU module, because when I disconnect it from...
  7. Closed: Re: FSK 1200baud discrete "modulators". What do you think?

    Hm...
    So 3 basic problems have reported to me. One is the phase (which based on the paper, could be ignored with suitable detection scheme), the other is the effectiveness of the detector when...
  8. Closed: Re: FSK 1200baud discrete "modulators". What do you think?

    I should have posted the whole "modem" block diagram before I got you into trouble. Here it is. The RX will use two narrow filters and a simple detector which will convert audio tones to voltage...
  9. Closed: FSK 1200baud discrete "modulators". What do you think?

    Hi
    I want to investigate the possibility of making a discrete FSK 1200 baud modulator operating from 5v and connected to the TTL UART of an MCU. The circuits have to be made as simple as possible...
  10. Closed: Re: Reducing 10K lineat potentiometer to 1K, what about lineatity then?

    are you sure? This is the circuit. The mentioned linear pot/resistance will replace the 47k log one in the circuit.
  11. Closed: Reducing 10K lineat potentiometer to 1K, what about lineatity then?

    Hi I have a 10k linear potentiometer with center detent (lock).
    If I connect a 1k parallel resistor to the potentiometer ends (carbon track ends), I could in theory reduce the value of the...
  12. Replies
    12
    Views
    2,494

    Closed: Re: USB to PS/2 adapter, how does this work?

    I have 3 of these converters, 2 of them are actually for mouse. They all worked with one of the two keyboards. In the other keyboard none of them worked. If they had a converter inside them, I would...
  13. Replies
    12
    Views
    2,494

    Closed: Re: USB to PS/2 adapter, how does this work?

    I have tested it. I took a USB keyboard that I had connected to a PC through a usb to PS/2 adapter and pluged it in the project. It has been powered up (three leds are on in the beginning and then...
  14. Replies
    12
    Views
    2,494

    Closed: Re: USB to PS/2 adapter, how does this work?

    The purpose would be that every USB keyboard could work in the PS/2 port.
    I wondered so, because if that was the case, then USB keyboards (not-combo) would work in a PC PS/2 but not in my project.
  15. Replies
    12
    Views
    2,494

    Closed: Re: USB to PS/2 adapter, how does this work?

    Well this are great news for the project. If the intelligence is inside the keyboard, then USB keyboards can be used with this project IF they support the PS/2 protocol.
    I guess the simplest thing...
  16. Replies
    12
    Views
    2,494

    Closed: USB to PS/2 adapter, how does this work?

    I have an MCU project that accepts PS/2 keyboard. I want to investigate if I could use USB keyboards as well with it using these USB to PS/2 adaptors.

    I think that the conversion from USB protocol...
  17. Replies
    7
    Views
    570

    Closed: Re: why FM is not used in shortwave?

    I see. It reminds me the digital voice ham radio modes. It uses also multiple carriers. It seems that digital signals go that way (using multiple digital data streams within the same "channel").
  18. Replies
    7
    Views
    570

    Closed: Re: why FM is not used in shortwave?

    Yes I should have corrected the topic title, I meant except CB radio.
    Is DMR FM modulated? I thought it was AM. Something like QASK or similar.
  19. Replies
    7
    Views
    570

    Closed: why FM is not used in shortwave?

    why FM is not used in shortwave?
    This is a long question I have. Whenever I switch the HF radio to FM, AM stations carriers are received more clear. Of course I am only hearing very low demodulated...
  20. Replies
    37
    Views
    2,129

    Closed: Re: HP 54520A Blown Fuse Problem

    I think is is the bridge rectifier. After I deslodered it, no fuse was blown. I have replaced all other parts except the varistor and the fuse was always blown. So it must be the bridge.

    This is...
  21. Replies
    37
    Views
    2,129

    Closed: Re: HP 54520A Blown Fuse Problem

    Hi,
    I have disconnected R12 and Q3 (isolating the input of the PSU completely) and the fuse is still blown.
    So the problem is somewhere on the input side of the PSU.

    Now, I have replaced the...
  22. Replies
    10
    Views
    822

    Closed: Re: Active HF phase shifter?

    I do not mind tuning for this application. But having to change the capacitor for each band is undesirable. Also having to tune both the phase AND the amplitude is undesirable, as it will be too...
  23. Replies
    10
    Views
    822

    Closed: Re: Active HF phase shifter?

    Thanks very much for the interesting simulation and ideas!
    I think I will stick to the RC circuit and try to correct any amplitude difference on later stages by ACG amplifiers or by a level...
  24. Replies
    2
    Views
    290

    Closed: bfq162 pnp comlementary?

    I need to find a pnp complementary for the bfq162 which is to be used in a class-C HF amplifier.
    Is there anyone complementary in the same package?
  25. Replies
    10
    Views
    822

    Closed: Re: Active HF phase shifter?

    What does it mean FvM? That with the values shown it won't have amplitude variations? Wave I understood that right?
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4