Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

HFSS Non-Manifold Edges

Status
Not open for further replies.

khaira

Newbie level 3
Joined
Aug 14, 2005
Messages
4
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,307
non-manifold edges hfss

Hi. I am new to HFSS and am encountering the following problem.

I am modeling two cascaded cavities and am getting the following error. 'Non-manifold edges found for ...'.

I have narrowed the problem to the point that I have removed all the walls except for a vertical plate attaching at the center of a a horizontal plate. I am still getting the problem.

I think that HFSS is confusing whether the attached edge is inner or outer. However, I don't know how to solve this problem.

I will really appreciate your comments.
 

non-manifold edges

I have had similar problems
This kind of problem occurs when two objects "touch" each other.refer figure (a)
The remedy is to make objects large enough that they overlap as shown in figure (b).
After that unite or intersect the objects as shown in figure (c).
I hope this will solve your problem
and your program will run happily.:D
tell me how to make a free mirror.
 
non manifold edges

good ,I got the problem too
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top