Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Altium Designer: Back annotation (update schematic with net changes from PCB)

Status
Not open for further replies.

backdrill

Member level 2
Joined
May 26, 2012
Messages
48
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,288
Activity points
1,568
Hello everyone,

I would like to seek advice on the proper way to doing back annotation with Altium Designer.
What is the proper way to update a schematic from PCB with net name changes?
 

In pcb,tools...> Re Annotate, there itself select particular position press ok here one .WAS file will be generate, After that go to schematics tools...> back annotate schematics then select corresponding .WAS file. and press Accept changes. Just show in below images
 
Hi,

Tools/Re-annotate
In PCB Editor
Design/update schematics go to schematics compile it.

Again In Schematic Editor
Design/update PCB
 
I am getting 0kb .WAS file generated from the Re-annotate command execution.
It won't allow me to back annotate the schematic. Is there a missing setup?
 

Oh! But re annotate should be generate .was file with data, can i share ur pcb ?
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top