jslee
Junior Member level 1
Hi,
I do a simulation about microstrip line based one the driven terminal soultion type.I set up two waveport one the two ends of the ustrip.But I find that the mesh is diffrent from the two sides.This causes the S11 or Zo is different at two port.This obviously is incorrect.May I make some adjustment to let the mesh symmerty?
Thanks for your help
Sincerely, Jslee
I do a simulation about microstrip line based one the driven terminal soultion type.I set up two waveport one the two ends of the ustrip.But I find that the mesh is diffrent from the two sides.This causes the S11 or Zo is different at two port.This obviously is incorrect.May I make some adjustment to let the mesh symmerty?
Thanks for your help
Sincerely, Jslee