Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

KCU105 configuration

Status
Not open for further replies.
W

wtr

Full Member level 5
Joined
May 1, 2014
Messages
299
Helped
29
Reputation
58
Reaction score
25
Trophy points
1,308
Activity points
4,108
Hello all,

I'm trying to help out with the following http://forums.xilinx.com/xlnx/board/crawl_message?board.id=XLNXBRD&message.id=14939

I can see the zynq config control, however since i don't have means to probe, I don't know if SYSCTLR_SDIO_MUX_SEL/OE is ever set, such that sd micro is connected to the fgpa. From what I can see it looks like it's just asking to initiated a boot from sd-micro, rather than use it as a data storage device.

Please could someone put my mind at rest. Does the user need to configure the uart - zynq each time, or can it be permenantly configure to link fpga to sd-micro. I come here because xilinx have been completely quite on this front.

Regards,
Wes
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top