Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Problems occur when IC50 installed on RHEL 3.0?

Status
Not open for further replies.

willyboy19

Full Member level 3
Joined
Feb 15, 2004
Messages
152
Helped
12
Reputation
24
Reaction score
2
Trophy points
1,298
Activity points
1,705
When tried to install IC50 on RHEL 3.0 (Kernel 2.4.21-4.EL), a bunch of errors show up:

Incorrectly built binary which accesses errno or h_errno directly. Needs to be fixed.

Can someone give some advise to solve this problem? Or RHEL 3.0 is not a friendly platform to support EDA tools?
 

Change your env setting as..

LD_ASSUME_KERNEL=2.4.1


that's it.
 

The error message actually happens when one tried to install IC50 during softload process:

Incorrectly built binary which accesses errno or h_errno directly. Needs to be fixed.

Meanwhile, even after changed the .cshrc file to include

set LD_ASSUME_KERNEL = 2.4.1

The same error message still pops out when 'icms' is launched. Do you have any idea how to fix this problem?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top