Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

[SOLVED] Photodiodes w/ JFET VCR feedback

Status
Not open for further replies.
R

RitchRock

Guest
Hi all, I'm working on an optical sensor and am looking to increase my SNR. I've constructed a circuit to cancel out LED emitter noise with feedback control. PDref monitors just the emitter, while PDsig carries the sensor signal + emitter noise. Feedback consists of integrator -> JFET VCR -> current divider. Please see attached circuit. LT Spice simulation works well, but in real-world implementation I don't see the JFET resistance changing (I believe it should balance when I move VR1). Any suggestions on what I could be missing from moving from the simulation to prototype?

PDs with JFET VCR.jpg
 
Last edited by a moderator:

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top