Sparky5
Junior Member level 1
Hi
I am new to these forums, and I just have a questions on layout design.
When receiving a schematic from a design engineer with the currents required on the power and ground lines. (or any other line) How do you calculate the width of the line required using the design rule manual? What would I need to do?
If someone could give an answer and also an example calculation, it would be very much appreciated.
Sparky5
I am new to these forums, and I just have a questions on layout design.
When receiving a schematic from a design engineer with the currents required on the power and ground lines. (or any other line) How do you calculate the width of the line required using the design rule manual? What would I need to do?
If someone could give an answer and also an example calculation, it would be very much appreciated.
Sparky5