Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
ADS manual recommends to use 2D layers instead of 3D vias. So, just connect transformer layers by conductive or resistive surface.The size of this object should be near the size of the real via to include current spreading. To be near the real life you need to pick up via resistance from the technology specification and set proper sheet resistivity of the vias.
Good luck.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
